DIY Waterproof Capacitive Analog Soil Moisture Sensor Kit – Adosia Ninja Compatible with Arduino / ESP8266 / ESP32 / Adosia IoT / Raspberry Pi

$6.95$29.95

Build your own waterproof and corrosion resistant moisture sensors using only a soldering iron and heat gun

This is moisture sensor is ideal for any Arduino, ESP8266, ESP32, Raspberry Pi, Adosia IoT or any other microcontroller project

Clear

Description

The Adosia Ninja DIY waterproof capacitive analog soil moisture sensor kit works with Arduino, Raspberry Pi, ESP8266, ESP32 and Adosia IoT systems – or any microcontroller capable of reading a 0-3V analog input signal range

A rugged and waterproof soil moisture sensor increases system reliability while lowering the total cost of ownership.  Without ruggedizing and waterproofing, the soil moisture sensor circuitry is all but guaranteed to short out when it gets the slightest bit wet

What You Receive:

  • Adosia Ninja Capacitive Analog Soil Moisture Sensor
  • strip 3/4″ glue adhesive-lined dual wall waterproof heat shrink
  • strip 3/8″ glue adhesive-lined dual wall waterproof heat shrink
  • 2.54mm female header connector wire
  • 2.54mm male right angle header pins (optional)
  • up to 30 ft shielded or unshielded cable (optional)
  • *female ground connector included with all shielded cables

Adosia Ninja Waterproof Moisture Sensor Features:

  • long and reliable field operating life
  • corrosion resistant by design
  • lowest total cost of ownership
  • input voltage: 3.3 ~ 5.0 VDC
  • output voltage: 0 ~ 3.0 VDC
  • low power consumption
  • compatible with Adosia IoT WiFi Control Modules
  • dimension: 98mm * 23mm (3.86in x 0.905in)

Applications:

  • self-watering pots and planters
  • personal cultivation setups
  • automated garden watering applications
  • nursery and tree care
  • IoT data applications

Additional information

Weight N/A
Dimensions N/A
onboard connector

none, 2.54mm right angle male header pin

cable length

no cable, 1 ft (unshielded), 3 ft (unshielded), 5 ft (shielded), 10 ft (shielded), 30 ft (shielded)

Reviews

There are no reviews yet.

Be the first to review “DIY Waterproof Capacitive Analog Soil Moisture Sensor Kit – Adosia Ninja Compatible with Arduino / ESP8266 / ESP32 / Adosia IoT / Raspberry Pi”

Your email address will not be published. Required fields are marked *