Description
The Adosia Ninja DIY waterproof capacitive analog soil moisture sensor kit works with Arduino, Raspberry Pi, ESP8266, ESP32 and Adosia IoT systems – or any microcontroller capable of reading a 0-3V analog input signal range
A rugged and waterproof soil moisture sensor increases system reliability while lowering the total cost of ownership. Without ruggedizing and waterproofing, the soil moisture sensor circuitry is all but guaranteed to short out when it gets the slightest bit wet
What You Receive:
- Adosia Ninja Capacitive Analog Soil Moisture Sensor
- strip 3/4″ glue adhesive-lined dual wall waterproof heat shrink
- strip 3/8″ glue adhesive-lined dual wall waterproof heat shrink
- 2.54mm female header connector wire
- 2.54mm male right angle header pins – OR – 2.54mm terminal block screw connector (optional)
- up to 30 ft shielded or unshielded cable (optional)
- *female ground connector included with all shielded cables
Adosia Ninja Waterproof Moisture Sensor Features:
- long and reliable field operating life
- corrosion resistant by design
- lowest total cost of ownership
- input voltage: 3.3 ~ 5.0 VDC
- output voltage: 0 ~ 3.0 VDC
- low power consumption
- compatible with Adosia IoT WiFi Control Modules
- dimension: 98mm * 23mm (3.86in x 0.905in)
Applications:
- self-watering pots and planters
- personal cultivation setups
- automated garden watering applications
- nursery and tree care
- IoT data applications
Reviews
There are no reviews yet.